Oline Contact

Contact me!

Tel: 86-519-68000720

Whatsapp/Skype/Wechat:

+86 15061960650

Contact Us
  • Tel: 86-519-68000720
  • Fax: 86-519-68856880
  • Mob: 8615061960650 Tracy
              
  • Add: NO.11 Chuangye East Road, Baizhang Industrial Park, Xinbei District, Changzhou, Jiangsu Province, China.
Home  >  News  >  Artificial turf bonding process

Artificial turf bonding process

03/11/2017

  Preparation before bonding:

  1. Must be bonded to the bottom of the turf, non-woven fabrics, seams and other clean, and the surface dry and no moisture.

  2. Ambient temperature should be selected at 5 ℃ above the construction is appropriate, and should not be in the rain and rainy weather construction, otherwise it will lead to too long bonding or even cause non-stick phenomenon.

  Specific construction process:

  1. Gluing: requires a brush in its surface brushing thickness uniformity, can not be repeated coating, otherwise there will be bubbling phenomenon, or even fall. Bottom cloth coated with glue, strictly control the thickness of the glue, pay attention to the appropriate glue, the coating should be applied to the bonding of the two bonding surface.

  2. Adhesive: according to the then temperature, humidity, pressure and other conditions of the real impact, reasonable control of drying time. Generally within 10-30 minutes after the glue, mortar to eighty-nine into dry to touch non-stick is appropriate. Bonding requires a one-time alignment. Do not move the bonded object back and forth after bonding.

  3. Press: After the glue is good, remove its surface debris, with a special rubber hammer from the adhesive to both sides of the force hammer, so that the surface of the full contact with dense, more solid bonding.

  4. Curing: the curing time is generally three days, the final strength is generally measured for ten days. Therefore, during curing must pay close attention to its maintenance, to avoid too much exposure, flooding and movement, in order to achieve the best state of bonding.

  5. After cleaning, do not rub the quartz sand and rubber particles before the site of the turf cut debris for cleaning